Assuming a HCF modem and does not work on all HCF modems, here is the format of the AT+ms string:
I would like to force a specific protocol and/or connection speed range for my
SupraMAX modem.
Syntax: AT+MS=<modulation>,<automode>,<minimum tx>,<maximum
tx>,<minimum rx>,<maximum rx>
You'll notice the receive speed follows the transmit speed with this command set.
The defaults for the settings are: +MS: K56,1,75,33600,75,56000
Modulation options: B103, B212, V21, V22, V22B, V23C, V32, V32B, V34, K56, V90
Automode options remain: 0, and 1
Available speeds: 75, 300, 1200, 2400, 4800, 7200, 9600, 12000, 14400, 16800,
19200, 24000, 26400, 28800, 31200, 33600, 34000, 36000, 38000, 40000, 42000,
44000, 46000, 48000, 50000, 52000, 54000, 56000
I am not able to get the SupraMax PCI card to work properly with system
under Windows 98. My motherboard contains the VIA chipset.
Look at the following web site:
http://www.via.com.tw/support/faq.htm
Try low and increment to higher speeds.
Good Luck,
Frank
At 02:36 PM 5/4/99 -0400, Lisa Casey wrote:
>Hi again,
>
>In regards to my posting about the above modem, I've now tried the following
>init strings:
>
>+ms=1.11.14400,28800
>& f + m s = V 3 4 , , , 2 8 8 0 0 , ,
>+MS=11,1,300,33600,300,33600
>
>the modem does not like any of these init strings. It will refuse to dial
>and DUN yeilds the following error: Error 630. The port was reset due to
>hardware failure.
>
>In regards to this suggestion I recieved:
>
>> A great site is www.56k.com, I have fixed many modem
>> problems with the info
>
>This isn't a 56K modem though. It's 33.6. I did look at the site, but there
>was no info for this modem there.
>
>Any other ideas??
>
>Thanks,
>
>Lisa Casey
>Interstate 2000, Inc.
>lisa@jellico.com
>
>
>
>
>
>
>
>-
>To unsubscribe, email 'majordomo@livingston.com' with
>'unsubscribe portmaster-modems' in the body of the message.
>
>
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-modems' in the body of the message.