Re: Radius with USR Total Control

Shikoli Makatiani (shikoli@africaonline.com)
Thu, 17 Oct 1996 03:08:54 -0400

Hi,
We use USR netservers anduse the snmp software to set the timeout. I
don't think their radius client supports the idle timeout setting.
If you update you netserver software to 3.1.7 --> available at
ftp.usr.com and
update your Netserver to 3.1.5 ---> available at ftp.usr.com. The
Netserver software
will allow you to set timeout.
(Go to the port's setup and you will see the timeout setting.)

Frank Heinzius wrote:
>
> Hi,
>
> On 16 Oct 96 at 9:57, Anthony McGarr wrote:
>
> > How do I enable the session limit parameters in Radius, everything
> > else works fine but it will not disconnect the user after a limit has
> > been reached. Does the Modem Control need to be enabled or disabled?
> >
>
> Enabled. Then you'll have CD and DTR enabled (DTR will be used for
> hangup). But this is for PortMasters only. NetServers use the packet
> bus, where modem control settings are ignored.
>
> But, you have a NetServer from USR? Sorry, but their code is based
> upon ComOS 3.1.4, which is outdated, and, no session-limit support
> over RADIUS.
>
> Frank
>
> --
> ***** The expressed opinions are totally mine! *****
> Frank M. Heinzius MMS Communication GmbH
> frimp@mms.de Eiffestrasse 598
> http://www.mms.de 20537 Hamburg, Germany
> Phone: +49 40 211105-0 Fax: +49 40 210 32 210
> ***** U.S.Robotics and Livingston Distributor *****