> Regarding these symptoms. I've just setup a 2er W/ 10 Async and 5 BRI.
>
>
> 1.) PMPConsole for Windows (*ugh*) is ultra bug ridden. Among other
> lossage it won't allow a SPID with a leading 0.
Haven't tried this, I use the command line. Seems to me that the Windows
software was pre-ISDN.
> 2.) after setting up the BRI ports by hand, the lights on the back of
> the unit were solid, but the ports would show 'NO SESSION' or whatever.
Probably "NO SERVICE".
> Telco said they could connect right up to my equipment. (Past the NT1)
>
> I had to power cycle and they came right back up.
Covered in the docs. You need to reboot for changes to ISDN switch type
to take effect.
> This was just 3 BRI's, leaving S16-19 unconfigured. The next day the
> telco hooked up the other two lines. Set them up by hand, they reset
> just fine W/O a need for a reboot or power cycle.
Probably because the switch type had been correctly specified by then.
----
WestNet: Internet service to Santa Barbara, Ventura and the world.
805-892-2133 805-289-1000 805-578-2121