problem with port s0

Scott Priddell (priddell@tmctech.com)
Mon, 17 Jun 1996 20:48:45 +0000

I have tried to connect to port s0 by setting up as a telnet port. I have
had no problem configuring ports s1 - s9. I cannot get s0 to show up as a
"printer" through pmconsole and I have used the instructions from the
webpage to configure the port from the command line. I setup s1 from the
command line and have cloned ports s2 - s9 and they seem to work properly.

I do a show s0 and the status is always "USERNAME". I have tried to reboot
the comm server, use a different cable, use a different modem and I still
can not telnet to the modem.

Checking "show netconns" port 6000 never shows up but 6001-6009 show up in
the list. I have also tried a different number than 6000.

I am not sure if there is something wrong with this port. I want to know
before I spend the time to configure the remaining ports as they all seem
OK. I need all 10 ports for the site I am setting up.

Any suggestions will be appreciated.

Thanks Scott
_______________________________________________________________________
Scott Priddell
Systems Consultant
Technology Management Corporation (TMC)
priddell@tmctech.com
(W) 306-545-4344 (F) 306-5453440