Re: ISDN bri card in middle port (fwd)

Simon Nuthall ((no email))
Mon, 17 Jun 1996 17:13:43 -0700 (PDT)

We are close to final release of the code and should be at a store near by
8-) When it becomes available we will post and all that jazz to make it
available to you. Till then

Simon

Once upon a time E. Todd Taylor shaped the electrons to say...
>
>In this case, the centre BRI is controlled by both MWAC's..the
>chip goes to sleep dude, so minusw reset's the offending chip..since
>the other wasn't reset that only fixes 1/2 of the BRI..a test release
>came out that improves on the problem, so check with simon to see
>where were at on this.
>
>Todd
>--
>On Mon, 17 Jun 1996, MegaZone wrote:
>
>> Once upon a time Robert Hanson shaped the electrons to say...
>> >someone did mention that a 5bri in the middle slot had some "issue" (i
>> >know not what it was) in terms of comos...
>>
>> Anyone have this around? I'd like to see what they were talking about.
>>
>> -MZ
>> --
>> Livingston Enterprises - Chair, Department of Interstitial Affairs
>> Phone: 800-458-9966 510-426-0770 FAX: 510-426-8951 megazone@livingston.com
>> For support requests: support@livingston.com <http://www.livingston.com/>
>> Snail mail: 6920 Koll Center Parkway #220, Pleasanton, CA 94566
>>
>
>E. Todd Taylor Livingston Enterprises Inc. Phone: (800) 458-9966
>Support Engineer 6920-220 Koll Centre Pkwy. Fax: (510) 426-8951
>todd@livingston.com Pleasanton, CA 94566 http://www.livingston.com
>
>