Re: Telnet Problem (fwd)
Chris Bell (cbell@compute.compute.com)
Wed, 26 Jun 1996 23:35:33 -0700
> At 02:29 AM 6/24/96 -0700, you wrote:
> >Once upon a time Bill Griffin shaped the electrons to say...
> >>I have a couple of connection problems to my Portmaster 2E30. Right now I am
> >>unable to Telnet to the Portmaster. I am able to access it through
> >>PMCONSOLE. However, when I try to view Netstats, PMCONSOLE terminates; then
> >>I am unable to get to the Portmaster by any means except via a hardwired
> >>terminal. I then rebooted the Portmaster and PMCONSOLE access comes back,
> >>but I still am unable to Telnet to it. Any suggestions? TIA.
> >
> >Could you have set the telnet port to something other than 23?
> >
>
> No, Telnet it's still set on Port 23 as viewed via PMCONSOLE general
> configuration data. I do have a USR Total Control System running on the same
> class C netmask. Both seem to run fine except for this difficulty. Any other
> ideas?
>
> Bill G.
Check to see if any ports are set for device service of telnet, with
the default port (23).
Chris.
Chris Bell, Senior Network Engineer Network Intensive/Compute Intensive, Inc.
cbell@compute.com KD6ZWR http://www.ni.net Phone 714-450-8400
8001 Irvine Center Drive, Suite 1130, Irvine, CA 92718 Fax 714-450-8410
------------------------------------------------------------------------------