set w1 address 0.0.0.0
set w1 netmask 0.0.0.0
etc etc
--->
Robert H. Hanson LAN/WAN Consultant - Internet Service Provider
Otis Orchards, Wa. Cutting Edge Communications www.cet.com
(509) 927-9541 finger: info@cet.com or email: roberth@cet.com
On Sun, 8 Sep 1996, Randy Moore wrote:
> At 12:13 PM 9/8/96 -0700, Robert Hanson wrote:
> >do a
> >
> >set w1 prot frame
> >save w1
> >reset w1
> >
> >then
> >
> >show w1
> >
> >see if it died.. make other minor adjustments as necessary...
> >
>
> I tried it, but it sill doesn't work. It seems that the W1 port never
> really resets because the active configuration never changes to the default
> configuration.
>
> Any other suggestions? Anyone?
>
> Here is what I typed and the results:
>
>
> pm1> set w1 proto frame
> Protocol for port W1 changed from ppp to frame_relay
> pm1> save w1
> Saving port W1
> New configurations successfully saved.
> pm1> reset w1
> Resetting port W1
> pm1> sh w1
> ----------------------- Current Status - Port W1 ---------------------------
> Status: CONNECTING
> Input: 0 Abort Errors: 0
> Output: 22518 CRC Errors: 0
> Pending: 0 Overrun Errors: 0
> TX Errors: 0 Frame Errors: 0
> Modem Status: DCD+ CTS+
>
> Active Configuration Default Configuration
> -------------------- ---------------------
> Port Type: Netwrk Netwrk (Dial In)
> Line Speed: Ext Clock Ext Clock
> Modem Control: on on
> Modem Config: Not Configured multi5
> Remote Host: 255.255.255.255 border1-serial4-0-8.Washington.mci.net
> Netmask: 255.255.255.255 255.255.255.252
> Interface: Unassigned (PPP,Quiet) (FRM,Routing)
> Mtu: 1500 1500
> Dial Group: 0
>
> - Randy Moore
> Atlantech Online, Inc.
> (301) 470-2977
> http://www.atlantech.net/
>