Here's the output of me dialing in, and the debug output from the PM:
Dialing...
CONNECT 64000
ETH/IIS Portmaster -- Authorized Use Only
login: office
Password:
Dialback Accepted
Call Terminated - Unspecified Cause (31)
S20: Sending Request Connect - 64Kbps / Data
S20: Received Connect - B1
S20: Link Protocol: V120 Rate Adaption
S20: Sending Disconnect Request
S20: Received Disconnect Ack
S20: Received Call Clear
sendthem (AT\r)
expect (\r)
Connection Failed
Is there something special that I need to set in order for this to
work as expected ? I tried setting NAS-Port-Type to ISDN (and ISDN-V120),
without any effect.
The problem is clear. On the 5BRI, when you send it AT, it responds with OK\r,
and not just \r; is there any way to override this ? I didn't find anything
in the manual -- our supplier sent us the board without *ANY* documentation; is
there seperate documentation for the 5BRI board, in addition to the PM2E
documentation ?
We are running ComOS 3.3.2.
/AWF
------------------------------------------------------------------------------
Internet: awf@iis.ee.ethz.ch Adam W. Feigin
UUCP:{backbones}!iis!feigin Network Systems Manager & CyberShaman
Mail: Integrated Systems Laboratory Institute for Integrated Systems
ETH-Zentrum Swiss Federal Institute of Technology
CH-8092 Zurich Zurich, Switzerland
Switzerland
Phone: +41 1 632 50 53 FAX: +41 1 632 11 94
http://www.iis.ethz.ch/~feigin
"I'd like to donate my body to science after I die, but I'm afraid its
taken far too much of it already"