So you lowered Dip Switch one and then power cycled the unit?
>Now I have a new problem I can not enter in the OR through the S0 with the
>dip swithc 1 down.
>Why? any ideas?
Looking at this you have a modem on that line, correct?
What happens when you dial into the modem?
>My configuration S0 is:
>i2000> sh s0
>----------------------- Current Status - Port S0 ---------------------------
> Status: IDLE
> Input: 450 Parity Errors: 0
> Output: 829 Framing Errors: 234
> Pending: 0 Overrun Errors: 0
> Modem Status: DCD- CTS-
>
> Active Configuration Default Configuration (* = Host
> -------------------- --------------------- Can Override)
> Port Type: Login Login (Security)
> Login Service: PortMaster PortMaster
> Baud Rates: 115200 115200,115200,115200
> Databits: 8 8
> Stopbits: 1 1
> Parity: none none
> Flow Control: RTS/CTS RTS/CTS
> Modem Control: on on
> Modem Config: Configured generico
> Hosts: default
>
> Terminal Type:
> Login Prompt: $hostname login:
> Idle Timeout: 3
The port looks ok, except the very high Framing Errors worries me a bit.
When you dial in, do you get the login prompt?
-MZ
-- Livingston Enterprises - Chair, Department of Interstitial Affairs Phone: 800-458-9966 510-426-0770 FAX: 510-426-8951 megazone@livingston.com For support requests: support@livingston.com <http://www.livingston.com/> Snail mail: 6920 Koll Center Parkway #220, Pleasanton, CA 94566 See me in person: Internet Expo, Boston, MA, October 16-17, Booth 422 ;-)