Just go through putting a a cisco 4700 to a pm2er via isdn with both ports.
As far as you're concerned all you have to do is put in a static route like:
add route xxx.xx.81.0 xxx.xx.81.1 2
then add their name(snmp) to your user table setting them for ppp of course
and then the mtu to 1500 plus the static address.
That's about it on your side.
Tell them to do chap and to point their next hope for routing to your
gateway to your provider and not the pm's ip address.
They have to do static routing and can do rip on their own net but they
would need to put in a few routes to go directly to your gateway out onto
the internet or wherever the outside world is.
Hope this helps,
Rick Osteen
Owner - Laser Service & Internet Access
1852 W. Paisano
El Paso, Tx. 79922
____ _
| __\_\_o____/_|
<[___\_\_-----<
| o'
http://www.1eagle1.com or email epadmin@1eagle1.com
Bring the whole tithe into the storehouse, that there may be food in my
house. Test me in this," says the LORD Almighty, "and see if I will not
throw open the floodgates of heaven and pour out so much blessing that you
will not have room enough for it.
** Malachi 3:10 **
OMAR - Osteen Modem Auto-Resetter
The 40 to 100 port ac recepticle box that controls the power to your modem
pool..
one by one that is.
url to http://www.1eagle1.com/omar to see more.