Jeremy Malli wrote:
>
> I've been using an application called InterMapper for my SNMP management.
> It basically shows me my entire network; routers, servers, modems,
> whatever, and displays the traffic flow, Ethernet and WAN errors in 30
> second intervals. I can have it email me or page me automatically if any
> section of the network goes down or receives too many errors. It's only
> available for the Mac though. You can find it at:
>
> http://www.dartmouth.edu/netsoftware/intermapper.html
>
> >Jeremy Malli wrote:
> >>
> >> I'm currently using two PM-2ER units, and was wondering how to setup the
> >> SNMP parameters on those units? My HP Routers show everything just fine,
> >> traffic flow, WAN Port Speed, Interface Type, etc... But the Livingston
> >> units simply show the interface type as 'other (Broadband)'. Is there a
> >> way to change this? The units work fine over our frame-relay connection,
> >> it's just a little annoying not being able to monitor traffic flow...
> >>
> >> Jeremy Malli - Visionary Communications, Inc.
> >> Your Link to the Future...
> >>
> >> Visionary Communications, Inc.
> >> 400 S. Kendrick, Suite 301
> >> Gillette, WY 82716
> >> Voice: (888) 682-1884
> >> FAX: (307) 682-2519
> >> Internet: jeremy@vcn.com
> >
> >I have been looking for a good solution to use the SNMP effeciantly. I
> >set up the Portmaster to use SNMP and got some software for SNMP but I
> >really dont see a use for SNMP. I know some people are going to screma
> >at me but remember I dont know much about SNMP. I just got it working
> >the other day. I would like to know what is the true use of SNMP and
> >what software should i use with it.
>
> Jeremy Malli - Visionary Communications, Inc.
> Your Link to the Future...
>
> Visionary Communications, Inc.
> 400 S. Kendrick, Suite 301
> Gillette, WY 82716
> Voice: (888) 682-1884
> FAX: (307) 682-2519
> Internet: jeremy@vcn