Re: Problems with FrameRelay setup ( kinda long )

Michael J. Hartwick (hartwick@primeline.net)
Sun, 20 Oct 1996 13:07:57 -0400 (EDT)

Try hand entering the IP address of the Cisco with the DLCI of 17. I seem
to recall a problem getting our PM's to ARP properly with a Cisco 2501.

On Sun, 20 Oct 1996, Thomas Arnold wrote:

>On Sat, 19 Oct 1996, Phil Docken wrote:
>
>> I would suggest you remove the dlci list fm the Livingston box, let it be
>> built from the frame switch
>> information. At that point, with any luck you will have a network with DLCI
>> 17 at the CISCO and 16
>> at the Livingston side.
>
>Tried that too. Not only does the Livingston build an empty DLCI list (
>just showing the DLCI, no IP ) but the Cisco continues to show No ARP
>requests recieved if I do a show frame traffic.
>
>I still lean towards the idea that its a GTE problem.
>
> +-----------------------------------------------+
> : Tom Arnold - No relation to Rosanne :
> : SysAdmin/Pres - TBI, Ltd ( inna.net ) :
> : The Middle Peninsula's Internet Connection :
> +-----------------------------------------------+
>

----------------------------------------------------------------------------
Michael J. Hartwick, VE3SLQ
Hartwick Communications Consulting
hartwick@primeline.net