I recently installed a remote POP using a PM2ER-30 and an older (ver
3.1.4) USR Netserver I had available. Here's basically my setup:
( )
( )------[Local Router]---[Radius/DNS Server]
--[My 'Net feed]---( Our Frame ) |
( Cloud ) |Local Ether
( ) | 204.101.212
| |Other PMs etc.
|
[POP Router/PM2]
|
|POP Ether 206.47.201
|
[Netserver]
My "local" system has been running smoothly for about 14 months (total
down time not over 16 hours!) DNS is fine. PMs running latest comOS.
Added remote POP. Have PM and Netserver validating on "local" Radius
server. Primary DNS is "local" Secondary is "Net Provider". Routing,
frame, etc. is fine.
Users log in and everything (except reverse validation!) works fine. Once
in a blue moon someone hits a site that requires reverse lookup. Works
okay on local system with hosts.rev in DNS setup.
How do I get users on the netserver (Class C: 206.47.201) to reverse
validate? the Radius/DNS server is on a different segment with Class C:
204.101.212. Can I enter the users from 206.47.201 in my hosts.rev table?
If so how do the entries look? Is there something I need to enter in the
Radius file? In the Netserver/PM2?
Your help is, as alway, greatly appreciated.
Regards,
Steve
Stephen B. Henry steve@headwaters.com
Director of Operations http://www.headwaters.com/
headwaters network http://www.headwaters.com/steve/
a division of WebNET Corporation member: HTML Writer's Guild
"As the most participatory form of mass speech yet developed, the
Internet deserves the highest protection from government intrusion..."
-- Philadelphia Federal Court in ruling sections of
the Communications Decency Act unconstitutional.