> We just bought 2 new PM2e units and configured them just like all the
> others we have done in the past. The ComOS is 3.3.2 We set up an ip
> address and a subnet mask of 255.255.255.0 on each through console
> connection through s0, saved the config and restarted them. Next we
> plugged them into the hub and neither one shows a valid connection to the
> hub. That is we get no light whatsoever on the hub port. We have tried
> different hubs and different patch cabling but still the units do not show
> valid connections to a hub. We are using 10bT part of the Ethernet
> interface.
>
> AM I forgetting something or are these units possibly damaged. I bought
> them from the same place about 1 week apart.
>
> Your thoughts are much appreciated.
>
Have you flipped the appropriate dip switches to use 10baseT? As shipped
the switches are set for 10Base2.
/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\
Patrick Greenwell (510) 943-5769 voice
Systems Administrator (510) 210-2000 modem
Value Net, Inc. (510) 943-1708 fax
\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/