> Below is a copy/paste of a PM2 ComOS 3.3.2c1 "show s4" reflecting a
> "Modem Config: None" entry. After doing a "reset s4" the port
> shows "Modem Config: Configured".
>
> Is the "Configured" keyword simply indicating the modem table
> entry was sent? I'm assuming the normal pm2 operation is to change
> that keyword to "none" after an incoming call is properly handled,
> right?
Not quite.
The state 'NONE' I've usually seen after 'attach'ing to a port and then
disconnecting. It is not the state after a call has compelete or been
handled.
'Configured' means that the modem table entry init string was sent and
the reply string was recieved. Please note that if there isn't a reply
string the port will show 'Configured' regardless of what actually
happened on the modem.
JGT
-- John G. Thompson Livingston Enterprises Inc. Phone: (800) 458-9966 JOAT(MON) 4464 Willow Road Fax: (510) 426-8951 support@livingston.com Pleasanton, CA 94588 http://www.livingston.com