Yes, this is correct.
>Question #1 : what is the "Resets" in the netstat ouput ?
>Name Ipkts Ierrs Opkts Oerrs Collis Resets Queue
>ether0 0 0 0 0 0 15312 0
>frmW1 1852545 0 1985958 0 0 0 0
Hmm. Check to make sure you don't have routing on for ether0. In fact, you
can disable the interface:
'set ether0 ip disabled'
'set ether0 ipx disabled'
That will disable both protcols on ether0.
>Question #2 : why do I receive every 30 sec. the following message with ptrace (permit all) on my PM2eR which is the same as above.
>icmp from CISCO_FR_REMOTE_ADD to PM2eR_W1_LOCAL_ADD type Destination Unreachable
Looks like the PM is trying to send something to/through the router and is
getting a dest unreachable. Is there a way to 'ptrace' on the Cisco to see
what the PM is sending to cause this reply?
-MZ
-- Livingston Enterprises - Chair, Department of Interstitial Affairs Phone: 800-458-9966 510-426-0770 FAX: 510-426-8951 megazone@livingston.com For support requests: support@livingston.com <http://www.livingston.com/> Snail mail: 4464 Willow Road, Pleasanton, CA 94588