I'm (not surprisingly) having a problem setting up a Frame Relay link for
the first time on a PM2ER30 (running COM/OS 3.3.1c1).
I am successfully establishing a connection to the Frame switch at the
Telco, and in debug mode, I can see the DLCI is set correctly, but I can't
ping the other end of my PVC. That other end is having exactly the same
problem, they can Establish, but can't ping my IP address. Both addresses
are in the same subnet.
My W1 config is shown below.
If anyone could suggest what to try next, or even good general references,
it would be much appreciated. If I've done something obviously stupid, let
me know that as well.
Thanks.
pm2> sh W1
----------------------- Current Status - Port W1 ---------------------------
Status: ESTABLISHED
Input: 1402694 Abort Errors: 3
Output: 4395277 CRC Errors: 0
Pending: 0 Overrun Errors: 0
TX Errors: 67 Frame Errors: 0
Modem Status: DCD+ CTS+
Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Netwrk Netwrk (Hardwired)
Line Speed: Ext Clock Ext Clock
Modem Control: on on
Modem Config: Not Configured cardinal
Local Address: 208.198.58.33 208.198.58.33
Netmask: 255.255.255.240 255.255.255.240
Interface: frmW1 (FRM,Routing) (FRM,Routing)
Mtu: 1500 1500
LMI Poll Int: 10 (seconds)
DLCI List: 151:208.198.58.35
Dial Group: 0