I recently upgraded one of our PM's to 3.3.3 and now S0 is good for
one maybe two calls then it gets stuck in USERNAME. I have (of course)
double checked the dip swtiches, yadda yadd... but they all seem fine.
I put the modem on another port and it has been working OK for almost
12hrs so I don't think it could be the modem or cable. DCD is getting
stuck high, but there is no logical reason why it would do so
sporadically on that one port and not others (configured identically BTW).
Any ideas suggestions here are welcome:
Here's what S0 looks like in a "normal" state, unfortunately I don't
have the "dead" state as it is a bit hard reproduce being somewhat
sporadic...
----------------------- Current Status - Port S0 ---------------------------
Status: IDLE
Input: 6405610 Parity Errors: 0
Output: 40291187 Framing Errors: 5
Pending: 0 Overrun Errors: 0
Modem Status: DCD- CTS+
Active Configuration Default Configuration (* = Host
-------------------- --------------------- Can Override)
Port Type: Login/Netwrk Login/Netwrk (Dial In) (Security)
Login Service: PortMaster PortMaster
Baud Rates: 115200 115200,115200,115200*
Databits: 8 8
Stopbits: 1 1
Parity: none none
Flow Control: RTS/CTS RTS/CTS
Modem Control: on on
Hosts: default
Terminal Type: ansi
Login Prompt: PCSLink the Business Internet Provider^login:
Idle Timeout: 15
Dial Group: 0
----------------------------------------------------------------------------
Ryan Mooney Phone (602)265-9188 PCSLink
ryan@pcslink.com Fax (602)265-9357 Internet Services
The world needs more bitter, twisted souls. It would be a much better place.
-----------------------------------------------------------------------------