Re: Again... ComOS 3.5
Kevin Hardy (kevin@structured.net)
Thu, 1 May 1997 11:20:15 -0700
>OK, nobody slapped me around on the first question about ComOS 3.5 I raised
>so I'll try again...
>
>Is there something in ComOS 3.5 (PM2eR) that would or has been seen to cause
>a problem with the WAN port?
>
>I ask because on a couple of occasions, since we upgraded a few days ago,
>the PM has locked up and when it does all I see is the RD light on the
>Adtran TSU lit. I know this is not a very good description but... it has
>only occured a couple of times. I can't telnet to it and it takes a power
>cycle to recover it.
>
>Other info... running Radius 2.0
>
>Is there a beta out that I may need to try?
>
>Along the same lines can I downgrade back to 3.3.3 safely?
>
>Thanks, David
Probably ran out of RAM. If you are using the WAN port on PM2ER/30 and have
many of the ports going I would recommend upgrading to 4 or 16MB of RAM.
Use standard 30pin 72NS/30pin simms. All simms must be the same ie 4MB=
4-1MB, 16MB=4-4MB. This will allow you to use OSPF which makes life much,
much easier.
------------------------------------------------------------------
Kevin Hardy - Dialup Services Manager - Structured Network Systems
kevin@structured.net - www.structured.net - Tel: 503.656.3530
- "Don't become to attached too being human, sooner or later we
all have to give that up."