I told CTC that I didn't need DTMF on the outbound side and they just keep
pounding it down my throat. On the livingston chart it says that DTMF is
required.
Two-state Dual-Tone Multifrequency (DTMF) Required N/A
http://www.livingston.com/Tech/Appnotes/app.ISDN-pm3-t1pri-prov.shtml
Do you have it working without it?
Thanks
Scott
At 07:56 AM 5/14/97 +0000, you wrote:
>On Wed, 14 May 1997, Scott Lagos wrote:
>
>> Can anyone provide me with precise CT1 line provisioning information for
>> the PM3 for use in NYNEXland Massachusetts. I have the PRI provisioning
>> all set and in place, but some of the information the NYNEX rep is asking
>> me about the CT1 is not listed on Livingston's Line Provisoning Chart.
>>
>> Here is what I have so far...anything else I need?
>>
>> ESF
>> E&M Wink
>> DTMF
>> NYNEX Provides Clocking (I think they always do on FlexPath)
>
>You don't need DTMF, save the $$.
>
>Also, you need B8ZS.
>
>
>-Matt
>--
>----------------------------------------------------------------------
>Matthew S. Crocker - Systems Administration matthew@crocker.com
>Crocker Communications Phone: (413) 587-3350
>PO BOX 710 Fax: (413) 587-3352
>Greenfield, MA 01302-0710 http://www.crocker.com
>----------------------------------------------------------------------
>
>