Re: How to setup routes for a dialout location on PM2 (ComOS 3.5) (fwd)

MegaZone (megazone@livingston.com)
Tue, 20 May 1997 17:20:33 -0700 (PDT)

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Stephen Fisher: "Re: TRACERT problem - 1st hop times out (fwd)"
Previous message: Jake Messinger: "Re: How to setup routes for a dialout location on PM2 (ComOS 3.5) (fwd)"
Maybe in reply to: MegaZone: "How to setup routes for a dialout location on PM2 (ComOS 3.5) (fwd)"
Next in thread: Ilia Zubkov: "Re: How to setup routes for a dialout location on PM2 (ComOS 3.5) (fwd)"

Once upon a time Jake Messinger shaped the electrons to say...
>But wont the thing get upset because the routes are not up?

When an on-demand location exits all the routes exist - but the interface
is 'suspended'. So it is ok to tell people the routes. And if there is
ever traffic, then the location comes up and the interface goes active.

-MZ

--
Livingston Enterprises - Chair, Department of Interstitial Affairs
Phone: 800-458-9966 510-737-2100 FAX: 510-737-2110 megazone@livingston.com
For support requests: support@livingston.com  <http://www.livingston.com/> 
Snail mail: 4464 Willow Road, Pleasanton, CA 94588

Next message: Stephen Fisher: "Re: TRACERT problem - 1st hop times out (fwd)"
Previous message: Jake Messinger: "Re: How to setup routes for a dialout location on PM2 (ComOS 3.5) (fwd)"
Maybe in reply to: MegaZone: "How to setup routes for a dialout location on PM2 (ComOS 3.5) (fwd)"
Next in thread: Ilia Zubkov: "Re: How to setup routes for a dialout location on PM2 (ComOS 3.5) (fwd)"