Re: OR-HS to Cisco 2501

Ing. Felipe Tribaldos (felipe@pty.com)
Tue, 27 May 1997 19:09:41 -0500 (GMT)

Cisco ports are set to HDLC encapsulatoin by default.
You must remember to set them to PPP. This is done at the port
setup.

conf terminal
int s0
ip unnunbered ether0
encapsulation ppp
ip tcp header-compression passive

This will set the cisco to VJ header compression, only if the other
side does to. IP unnumbered will do an unnumbered link.
In the OR set the sx port t0 0.0.0.0 and netmask 0.0.0.0

rgds;

FT

>
> Has anyone setup the OR-HS to the Cisco 2501 and if so do you have a
> break down of the steps or what to watch out for. Mostly Cisco info
> required since the OR-HS is standard Livingston.
>
> Want to do unumbered interface.
>
> Thanks Eugene
>
> 

-- 
 ___________________________________________________________________________
| Ing. Felipe Tribaldos                                                     |
| Gerente de Operaciones / Operations Manager   Tel. +(507)265-2022/269-3571|
| CyberMedia Panama                             Fax. +(507)264-6082         |
| Internet Access - Web Publishing                                          |
| url: http://www.pty.com/                      mailto: felipe@pty.com      |
| __________________________________________________________________________|