----- debug begin -----
atdt 3798232
S0: Sending Call Request - 3798232
D0: send 00 01 08 08 08 02 00 05 05 04 02 88 90 18 03 a9 83 81 70 08 80 33
37 39 38 32 33 32
D0: recv 00 01 01 0a
Dialing...
D0: recv 02 01 08 0a 08 02 80 05 5a 08 02 82 b6
D0: send 02 01 01 0a
S0: Received Disconnect Clear Incoming Call Barred (B1 ID:8001)
S0: Redialing at alternate 56Kbps rate
S0: Sending Call Request - 3798232
D0: send 00 01 0a 0a 08 02 00 06 05 04 04 88 90 21 8f 18 03 a9 83 81 70 08
80 33 37 39 38 32 33 32
D0: recv 00 01 01 0c
D0: recv 02 01 0a 0c 08 02 80 06 5a 08 02 82 b6
D0: send 02 01 01 0c
S0: Received Disconnect Clear Incoming Call Barred (B1 ID:8001)
Call Terminated - Incoming Call Barred (54)
NO CARRIER
----- debug end -----
Can someone tell me what's going on? I was under the impression that
the PM3 was pretty much a plug and go device in this respect (meaning
dialin and dialout services), especially if a PRI was used. Checking
line0 shows the following:
---------------------- line0 - T1 Primary Rate ISDN ---------------
Status: UP Framing: ESF Encoding: B8ZS PCM: u-law
Receive Level: +2dB to -7.5dB
Alarms Violations
----------------------------- -----------------------------
Blue 0 Bipolar 0
Yellow 0 CRC Errors 0
Receive Carrier Loss 0 Multiframe Sync 0
Loss of Sync 0
I'm in GTE land and when I called to ask them they act as if I'm the
only person in history to have ordered a PRI. I'm convinced it's on their
end, so the more information I have going into 'battle' with them the
better.
Mike