>
> I just installed a PM3 using one PRI, but so far it doesn't work.
> Whenever I dial into it I just get a busy signal, and when I try dialing
> out I get the following info (I have set debug isdn and set debug isdn-d
> set and the telephone number is my existing modem pool on a PM2):
>
[debug snipped]
the below mirrors our setup.
What switch are you going through? If they are using a GTD-5 have them
contact Patti Silva at GTE HawTel, she got us up and running is a !snap!
8)
Hope you get it going soonest!
>
> Can someone tell me what's going on? I was under the impression that
> the PM3 was pretty much a plug and go device in this respect (meaning
> dialin and dialout services), especially if a PRI was used. Checking
> line0 shows the following:
>
> ---------------------- line0 - T1 Primary Rate ISDN ---------------
>
> Status: UP Framing: ESF Encoding: B8ZS PCM: u-law
>
> Receive Level: +2dB to -7.5dB
>
> Alarms Violations
> ----------------------------- -----------------------------
> Blue 0 Bipolar 0
> Yellow 0 CRC Errors 0
> Receive Carrier Loss 0 Multiframe Sync 0
> Loss of Sync 0
>
> I'm in GTE land and when I called to ask them they act as if I'm the
> only person in history to have ordered a PRI. I'm convinced it's on their
> end, so the more information I have going into 'battle' with them the
> better.
>
> Mike
>
-- Aloha,Sherwood