I have the following problem:
1- I have a PM2ei-ST with 10 ports ( 20 B ISDN channels)
2- The PM2ei- ST ( Europe) was working properly untill a week. The
configuration is OK......The users could connect and go to Internet.
3- The users use the Racer ISDN card from Attachmate. It works OK.
4- This week the user can NOT connect. When they call the connection is failed.
If I see the status of the port with "sh s4 " command:
--------------------- Current Status - ISDN Port S4
------------------------
Status: IDLE
Input: 0 Abort Errors: 0
Output: 0 CRC Errors: 0
Pending: 0 Overrun Errors: 0
TX Errors: 0 Frame Errors: 0
Modem Status: DCD- CTS- TELCO+ NT1- Disconnect: Temporary
Failure <-------------<-------------<------------
Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Login/Netwrk Login/Netwrk (Dial In)
Line Speed: 64000 64000
Terminal Type:
SPID: 5
Directory No: 5
Dial Group: 0
+++++
The problem is :
Disconnect: Temporay Failure
Some times it says disconnect: Normal Clearing and others the abort error
has a diferent number from 0.
The normay status is.
Nothing in Disconnect:
--------------------- Current Status - ISDN Port S4
------------------------
Status: IDLE
Input: 0 Abort Errors: 0
Output: 0 CRC Errors: 0
Pending: 0 Overrun Errors: 0
TX Errors: 0 Frame Errors: 0
Modem Status: DCD- CTS- TELCO+ NT1- Disconnect: <--------
Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Login/Netwrk Login/Netwrk (Dial In)
Line Speed: 64000 64000
Terminal Type:
SPID: 5
Directory No: 5
Dial Group: 0
I tried to do reset s4, reset d2.....NOTHING
I need to reboot the PM2 and the iSDN line ( net1) to allow user connect.
What could be the solution?
May be the problem is the ISDN line that block the port?
any solution?
Thank you for your help and time.
Regards,
Fernando Martin
Interlinea2000
www.i2000.es
+34-(943)-619101