Will it work if you turn it on on the entire interface and then use ospf
area ranges to turn it on and off on each sub-interface?
Another thing I would like to see is the ability to do OSPF on dial-out
locations! RIPv1 just doesn't cut it for these kind of lines.. If
Livingston supported RIPv2 it could I could live with it though. Why
can't you do OSPF on dial-out locations anyway?
On Sat, 31 May 1997, Alex Rubenstein wrote:
> I have configured a subinterface on a frame port:
>
> nac-den1> sho loc nyc1
> Location: nyc1 Type: Sub-Interface
> IP Address: nac-den1-s1-121-768k. Netmask: 255.255.255.252
> Protocol: Frame Relay Options: Quiet, VJ-Comp
> Group: 21 Mtu: 1500
>
> IP DLCI's: DLCI Address
> ----- ------------
> 121 207.99.8.121
>
> How do I turn OSPF on on this?