show line0 gives me:
line0 - E1 Primary Rate ISDN
Status: UP F1 Framing: CRC4 Encoding: HDB3 PCM: a-law
Violations:
Bipolar 0
CRC4 0
E-Bit 107
FAS Bit 0
The E-Bit errors are not increasing though (I have logged a call with the
Telco none the less).
show s0 gives me:
Status: NO-SERVICE
Modem-Status: DCD- CTS+ TELCO+
show m0 gives me:
Card Type: LU1675 Chipset
State: Ready
Now, a search on the WWW pages tells me that DCD- CTS+ TELCO+ means the
line and switch type is fine but the SPID is not set. However, I didn't
know you have to set a SPID on EuroISDN lines and further down the page
indeed it says that SPID's only need to be set for US isdn.
Help?
Regards,
Mikel
-- ----------------------------------------------------------- Mikel Lindsaar | "The dream is the foundation, mikel@sub.net.au | of our society!" ----------------------------------------------------------- SubNet! http://www.sub.net.au/ ------------------------------------------------------------ To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message. Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>