Those are for the user end, no? The user side config's are correct because
they do log in eventually. Were there erasures in the PM3 configuration?
Here is the gist. I am dialing in to my PM3's from home using a Pipeline
75. I dial several times, but each time it shows me connect for an instant
but never brings the channel up <on my router>. Then it disconnects. I
dial again. Same thing. After about 7 tries I get one channel up, some
times the first channel, sometimes the second, but only one channel. After
about 10 more tries both channels sync and I am finally running at 128k. No
in my PM3 radlogs it shows nothing of my failed attempts. Tis like I never
tried. This is also happening with people using regular 3Com Impact modems.
It all started after the upgrade to
3.8.2c2. My regular modem customers are happy with the upgrade, accept for
a few HCF user <grr>.
For my info in my PM3's:
All PRI with switch of att-5ess
Thanks.
Philip
-
--Philip Kish ~~~~~~~~~~~~~~~~~~~~~~~~~~~ http://www.ithink.net ~~~~~~~~~~ iThink, Inc.
(941) 299-6372
- To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-modems' in the body of the message.