>At 11:23 AM 07/08/96 +0000, you wrote:
>
>>ethernet with an IP in his subnet. How do I set up the Pm2e to route
>>packets for this separate subnet through a PPP connection?
>
>3 important entries in the radius file - his gateway address, a subnet
>netmask, and the routing information.
>
> Framed-Address = 196.28.25.129,
> Framed-Netmask = 255.255.255.248
> Framed-Routing = Broadcast-Listen,
> Framed-Filter-Id = "",
> Framed-Route = "196.28.25.130 196.28.25.129 1",
> Framed-Route = "196.28.25.131 196.28.25.129 1"
> Framed-Route = "196.28.25.132 196.28.25.129 1"
> Framed-Route = "196.28.25.133 196.28.25.129 1"
> Framed-Route = "196.28.25.134 196.28.25.129 1"
Would something like:
Framed-Address = 196.28.25.129,
Framed-Netmask = 255.255.255.248
Framed-Routing = Broadcast-Listen,
Framed-Filter-Id = "",
Framed-Route = "196.28.25.128 196.28.25.129 1"
not work as well, but less routes to be added? It would likely require a
entry in the PM's netmask table, but I think that one route is better then
5. Please I think I read something somewhere the you could only add 4
routes like this in Radius.
>
>Graeme
>
>
>---
>FastLight Data Distribution cc - Your Internet 'Solution' Provider
>Tel +27-(0)11-706-0212 Fax +27-(0)11-706-0812
> Info : info@fast.co.za
>http://www.fast.co.za Sales: sales@fast.co.za
>
>
>
----------------------------------------------------------------------------
Michael J. Hartwick, VE3SLQ
Hartwick Communications Consulting
hartwick@primeline.net