I tried numerous combinations of syntax, and I tested
each one of these combinations, by telneting to the NAS.
But instead of obtaining the NAS prompt, I get the
following error message: "Authentication failed"
Assuming the following:
username of my user is : toto
that the IP address of my NAS is : A.B.C.D
and that the type of my connection is: async
I have tried all of the following:
--------------------------------------------
toto Auth=System
Service-Type=NAS-Prompt-User
--------------------------------------------
toto Auth=System
Service-Type=NAS-Prompt-User,
NAS-IP-Address=A.B.C.D
--------------------------------------------
toto Auth=System
Service-Type=NAS-Prompt-User,
NAS-IP-Address=A.B.C.D,
NAS-Port-Type=Async
--------------------------------------------
toto Auth=System,Service-Type=NAS-Prompt-User
NAS-IP-Address=A.B.C.D,
NAS-Port-Type=Async
--------------------------------------------
toto Auth=System, Service-Type=NAS-Prompt-User, NAS-Port-Type=Async
NAS-IP-Address=A.B.C.D,
but they all failed ..
Am I missing an attribute (may more) ??
In the manual of Radius2, there is no example about the
"NAS-Prompt-User" ..
Thank you ..
______________________________________________________________
Joe Bou-Farah jboufara@matrox.com
Departement MIS tel: (514)-969-6000 ext.2304
Systemes Electroniques Matrox
1025 St-Regis
Dorval, Quebec
H9P - 2T4
______________________________________________________________