1) I believe you need ComOs 3.5 or higher
2) I thought it was:
user Auth-Type = System
Service-Type = NAS-Prompt-User
Mury
mury@goldengate.net 612-574-2200 Office
GoldenGate Internet Services 612-574-2444 Fax
50% Swedish 50% Hungry ;)
On Wed, 4 Jun 1997, Joe Bou-Farah wrote:
>
> I ve been trying to set a RADIUS account that can open a
> NAS-Prompt.
>
> I tried numerous combinations of syntax, and I tested
> each one of these combinations, by telneting to the NAS.
> But instead of obtaining the NAS prompt, I get the
> following error message: "Authentication failed"
>
>
> Assuming the following:
>
> username of my user is : toto
> that the IP address of my NAS is : A.B.C.D
> and that the type of my connection is: async
>
>
> I have tried all of the following:
>
> --------------------------------------------
>
> toto Auth=System
> Service-Type=NAS-Prompt-User
>
> --------------------------------------------
>
> toto Auth=System
> Service-Type=NAS-Prompt-User,
> NAS-IP-Address=A.B.C.D
>
> --------------------------------------------
>
> toto Auth=System
> Service-Type=NAS-Prompt-User,
> NAS-IP-Address=A.B.C.D,
> NAS-Port-Type=Async
>
> --------------------------------------------
>
> toto Auth=System,Service-Type=NAS-Prompt-User
> NAS-IP-Address=A.B.C.D,
> NAS-Port-Type=Async
>
> --------------------------------------------
>
> toto Auth=System, Service-Type=NAS-Prompt-User, NAS-Port-Type=Async
> NAS-IP-Address=A.B.C.D,
>
>
> but they all failed ..
>
> Am I missing an attribute (may more) ??
>
> In the manual of Radius2, there is no example about the
> "NAS-Prompt-User" ..
>
>
>
>
> Thank you ..
>
>
> ______________________________________________________________
>
> Joe Bou-Farah jboufara@matrox.com
> Departement MIS tel: (514)-969-6000 ext.2304
> Systemes Electroniques Matrox
> 1025 St-Regis
> Dorval, Quebec
> H9P - 2T4
> ______________________________________________________________
>
>
>
>