>
> Hi,
>
> I know this was covered about a month ago, but I wasn't paying attention,
> and seem to have misplaced some of the posts I saved regarding the
> undocumented and unsupported feature of modem tables, and how to use them
> to reset your modems after a power failure.
>
> Because I like to set the modems a certain way & leave them that way, and
> forbid users to muck about with the modem settings (or to reset them when
> they're finished), all that's needed here to reset the modem is "ATZ0".
>
> Problem is, the serial ports on the PM-2E are locked at 57600, but the
> default powerup DTE speed of these SupraFAXmodems is 28800. However, it
> will keep the DTE speed at the speed of the last valid AT command.
>
> I have done the following:
>
> > add modem supra SupraFAXmodem288 57600 ATZ0 OK
> > set s0 modem supra
>
> (saving & resetting and all).
>
> However, when I reset the port, it doesn't set the DTE speed of the modem
> (i.e. does not send the ATZ0 command).
>
> Since I can't find the instructions I [thought I] saved [somewhere, I'm
> sure! ;-)], can some kind soul on the list please tell me what I've left
> out or done wrong?
>
> Thanks.
>
> --
> -------------------------------------------------------------------------------
> Allen J. Newton BASIS International Ltd, (505)-345-5232
> 5901 Jefferson NE, Albuquerque, New Mexico 87109
> anewton@basis.com Network Administrator <*>
>
-- sameer Voice: 510-601-9777 Community ConneXion FAX: 510-601-9734 An Internet Privacy Provider Dialin: 510-658-6376 http://www.c2.org (or login as "guest") sameer@c2.org