Re: Unused WAN port filling logs with error messages

Randy Moore (ramoore@atlantech.net)
Sun, 08 Sep 1996 15:18:29 -0400

At 12:13 PM 9/8/96 -0700, Robert Hanson wrote:
>do a
>
>set w1 prot frame
>save w1
>reset w1
>
>then
>
>show w1
>
>see if it died.. make other minor adjustments as necessary...
>

I tried it, but it sill doesn't work. It seems that the W1 port never
really resets because the active configuration never changes to the default
configuration.

Any other suggestions? Anyone?

Here is what I typed and the results:

pm1> set w1 proto frame
Protocol for port W1 changed from ppp to frame_relay
pm1> save w1
Saving port W1
New configurations successfully saved.
pm1> reset w1
Resetting port W1
pm1> sh w1
----------------------- Current Status - Port W1 ---------------------------
Status: CONNECTING
Input: 0 Abort Errors: 0
Output: 22518 CRC Errors: 0
Pending: 0 Overrun Errors: 0
TX Errors: 0 Frame Errors: 0
Modem Status: DCD+ CTS+

Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Netwrk Netwrk (Dial In)
Line Speed: Ext Clock Ext Clock
Modem Control: on on
Modem Config: Not Configured multi5
Remote Host: 255.255.255.255 border1-serial4-0-8.Washington.mci.net
Netmask: 255.255.255.255 255.255.255.252
Interface: Unassigned (PPP,Quiet) (FRM,Routing)
Mtu: 1500 1500
Dial Group: 0

- Randy Moore
Atlantech Online, Inc.
(301) 470-2977
http://www.atlantech.net/