Issue an *ifconfig* from the command line of the portmaster.
You should see the following.
- ether0: flags=40106<IP_UP,IPX_DOWN,BROADCAST,PRIVATE,OSPF>
Also *show ether0* does the " cost,hello and dead-timers match the settings
on gated.
> I ran ptrace on the
>PM3, but I don't see the incoming helos from the gated system.
The command to look at OSPF hello packet is as follows.
- set console
- set debug ospf-m on|off
> Also, gated does not have an authentication "ID" setting when using md5
>authentication. Does it default to "1"?
If your asking, does the pm3 default to 1 if MD5 is being used?
The answer is, No. If MD5 is disabled the ID is not used.
If all this is OK, send e-mail to dave@livingston.com directly on Monday
with a phone number I can reach you at and I'll take a closer look then.
David Berger
Livingston Enterprises