Re: RJ-48C?

Ronnie D. Franklin (ronnie@itexas.net)
Wed, 11 Dec 1996 23:04:08 -0600

I really do not believe that they will bring both PRI's into one RJ-48C..
While they could I do not believe that the Telcos have a standard like
that.. but I'm not sure.. If the do bring both into a single RJ48 then it
would be real simple to make a cable..... Just attach a RJ45 to one end of
the cable.. then if they follow any standards.. the left 2 wires and the
right 2 wires will be one PRI and the middle 4 will be the other PRI..

----------
> From: Stephen Fisher <lithium@cia-g.com>
> To: Ronnie D. Franklin <ronnie@itexas.net>
> Cc: Evan Champion <evanc@synapse.net>; portmaster-users@livingston.com
> Subject: Re: RJ-48C?
> Date: Wednesday, December 11, 1996 10:51 PM
>
>
> If I understood Evan's message correctly, his phone company is setting it
> up so that both PRI's come in through the one RJ-48C jack right?
>
> What would you do then.. bulid your own litle break out box which splits
> the pairs into two jacks?
>
> On Wed, 11 Dec 1996, Ronnie D. Franklin wrote:
>
> > An RJ-48C is an RJ-45 with a tab on the side of the connector.. The
RJ-45
> > is actually a Audio or Analog connector.. An RJ-45 connector will work
> > fine into an RJ-48C jack.
> >
> > > From: Evan Champion <evanc@synapse.net>
> > >
> > > Bell is coming to do our 2 PRI install tomorrow. Apparently what
they
> > > are doing is putting in an HDSL box which has a single RJ-48C port
> > > which will carry both PRIs.
> > >
> > > My question is what am I supposed to do with the RJ-48C? The PM3 has
> > > dual RJ-45 ports rather than an RJ-48C.