RE: Unsetting values (fwd)

MegaZone (megazone@livingston.com)
Tue, 31 Dec 1996 12:06:56 -0800 (PST)

Once upon a time Tim Moloney shaped the electrons to say...
>Do I have to be logged in from S0 as console? The reason I ask is
>that I did it from a telnet session and nothing appeared to change.
>It paused approximately 5 seconds then displayed
>
> "Successfully formatted FLASH2"
>
>but a "show global" displays all the old (non-factory) settings.

I should have said you need to reboot.

Note that this means the IP is gone to, so put a console on S0.

Do not *save all* before rebooting our you'll be back where you started -
resaving all the settings in RAM to FLASH.

-MZ

--
Livingston Enterprises - Chair, Department of Interstitial Affairs
Phone: 800-458-9966 510-426-0770 FAX: 510-426-8951 megazone@livingston.com
For support requests: support@livingston.com  <http://www.livingston.com/> 
Snail mail: 4464 Willow Road, Pleasanton, CA 94588