Re: Resetting PM2e

Stavros Patiniotis (stavros@esc.net.au)
Thu, 1 May 1997 17:31:02 +0930 (CST)

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Phil Taylor: "RE: Livingston support??"
Previous message: Stavros Patiniotis: "Resetting PM2e"

> What is the command to reset the pm2e to the default configuration, ie
> lose ALL configuration aspects of it!!
>
> I have seen it mentioned here before......

Actually forget it the unit is as good as a boat anchor! The status
light wont even flash after a reboot.....its going back!!

Regards,

Stavros Patiniotis
------------------------------------------------------------------------------
-System Administrator / Network Manager Escape.Net -
- 465b South Rd -
-email: stavros@esc.net.au Keswick SA 5035 -
-URL: http://www.esc.net.au Ph 82932526 Fax 82932949-
------------------------------------------------------------------------------

Next message: Phil Taylor: "RE: Livingston support??"
Previous message: Stavros Patiniotis: "Resetting PM2e"