> Hi everybody:
> I'm an ISP/portmaster newbie that has a PM3 plugged into 2
> channelized T-1 lines that are being turned up by Pac Bell. Right
> now, calls to the CT-1 phone # get a busy signal. (This busy signal
> has a shorter delay between tones than a "normal" busy signal.) What
> I'd really like to know is, what is the minimal set of configuration
> commands that need to be entered in order to get the digital modems to
> answer the incoming call?
'FAST BUSYs' are normally indicative of 1) misconfigured phone switch or
2) an overloaded phone switch.
Otherwise, your modems should answer irregardless of not having fully
configured.
-- Aloha,Sherwood