-----Original Message-----
From: Erik P. Power [mailto:erik@sitespecific.net]
Sent: Sunday, March 07, 1999 4:53 PM
To: support@livingston.com
Subject: Problem with PMVision v1.2
System: PM3 w/ ComOS 3.8.2
2 CT1s configured ESF, B8ZS, FXS loop start
IP, OSPF, SNMP enabled
PMVision 1.2 Release
Symptoms: In the command window of PMVision, a 'sh netc' produces the
desired results. If, however, I immediately issue another 'sh netc' after
the previous 'sh netc''s results appear in the output window, the PM3
reboots itself. This has been observed twice in two days (I won't be trying
it again, for obvious reasons)--the two times this behavior was observed
were the only two times I issued two consecutive 'sh netc' commands; I'm two
for two on this one. There's nothing else to report, really, but here's the
output of a few 'sh' commands that might be helpful:
an1> ver
Livingston PortMaster PM-3 ComOS 3.8.2
System uptime is 10 minutes
an1> sh mem
System memory 4194304 bytes - 3176236 used, 1018068 available
112:2 272:2 416:2 144:2 2048:2 208:1 1168:0 176:0 4240:3 96:2 64:2 592:2
2064:0 128:2 80:0 16:2 160:3 32:9 48:2
System nbufs 2558 - 51 used, 2507 available
System blocks 576 - 8 used, 568 available
an1> sh modu
Module State Start Len
---------------- ----- ------ ---------
0 SNMP ACT 106888 29480
1 IPX HEAP 1028e8 16288
2 INIT HEAP ff000 14568
3 SYNC HEAP 15db98 13632
4 OSPF ACT 170ab0 53808
5 BGP HEAP 1610d8 63960
6 ISDN ACT 10e188 282640
7 ISDN-NORTH-AM ACT 153198 11040
8 ISDN-EUROPE HEAP 155cb8 21088
9 ISDN-JAPAN HEAP 15af18 3484
10 ISDN-AUSTRALIA HEAP 15bcb8 7900
an1> sh line0
---------------------- line0 - T1 Inband DS0 ---------------
Status: UP Framing: ESF Encoding: B8ZS PCM: u-law
Signaling: FXS loop start
Receive Level: +2dB to -7.5dB
Alarms Violations
----------------------------- -----------------------------
Blue 0 Bipolar 0
Yellow 0 CRC Errors 0
Receive Carrier Loss 0 Multiframe Sync 0
Loss of Sync 0
an1> sh line1
---------------------- line1 - T1 Inband DS0 ---------------
Status: UP Framing: ESF Encoding: B8ZS PCM: u-law
Signaling: FXS loop start
Receive Level: +2dB to -7.5dB
Alarms Violations
----------------------------- -----------------------------
Blue 0 Bipolar 0
Yellow 0 CRC Errors 0
Receive Carrier Loss 0 Multiframe Sync 0
Loss of Sync 0
Thanks...
______________________________________________________
Erik P. Power Site Specific, Inc.
erik@sitespecific.net 1402 3rd Ave. Suite 324
Voice: (206) 652-0677 Seattle, WA 98101
Fax: (206) 652-0676 http://www.sitespecific.net
______________________________________________________
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>