Re: (PM) Unit status 0x4

Thomas C. Kinnen (tkinnen@livingston.com)
Tue, 09 Mar 1999 14:21:32 -0800

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Portmaster: "Re: (PM) Compaq Presario 56k-df"
Previous message: Thomas C. Kinnen: "Re: (PM) Configuring a PM2E30"
Maybe in reply to: Jake Messinger: "(PM) Unit status 0x4"
Next in thread: Thomas C. Kinnen: "Re: (PM) Unit status 0x4"

Jake Messinger wrote:
>
> I am getting this error on a new pm 3:
>
> UNIT_STATUS 0x4.
>
> This isnt by any chance caused with the NEW modem cards and com os 3.8 is
> it?

Pull the modem cards and boot up with no modems installed. If it comes up
then upgrade to ComOS 3.8.2 and then install the modems and reboot.

-- 
Thomas C Kinnen - <tkinnen@ra.lucent.com> <tkinnen@sobhrach.com>
[RADIUS Test Engineer] - LUCENT Technologies RABU
"All of the opinions stated above are my own and not my employer's,
unless they were given to me by my employer"
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>

Next message: Portmaster: "Re: (PM) Compaq Presario 56k-df"
Previous message: Thomas C. Kinnen: "Re: (PM) Configuring a PM2E30"
Maybe in reply to: Jake Messinger: "(PM) Unit status 0x4"
Next in thread: Thomas C. Kinnen: "Re: (PM) Unit status 0x4"