When i logged in to PM3 using PM Console software, each port is showned
on "Network type" as Dial in & Out ...
Any idea ?
Channelized T1 configuration was enabled on PM3 before itself...
Thanks in advance....
With Warm Regards
Shibu R
_________________________________________________
Mailto : Shibu.Nair@med.ge.com
shibur@wipsys.soft.net
Tel : (414) 524 5261
Fax : (414) 896 2790
GE Medical Systems
Global Service Engineering
Pewaukee
Waukesha, WI 53072
----------
From: Thomas Kinnen[SMTP:tkinnen@livingston.com]
Reply To: Thomas Kinnen
Sent: Monday, March 15, 1999 3:53 PM
To: Nair, Shibu (MED, Wipro Systems, Inc); Mail List -
Portmaster Users
Subject: Re: (PM) Channelized T1 config
"Nair, Shibu (MED, Wipro Systems, Inc)" wrote:
>
> Thank you
>
> Another question, How do i invoke atdt prompt to dial out and
test as
> soon as i connectT1 on my portmaster 3....
Dial out is not supported on CT1. Dial out is only supported on
PRI at
this time.
> I just want to confirm the T1 connectivity using atdt
command....
Try dialing into it from a standard phone line.
--
Thomas C Kinnen - <tkinnen@livingston.com>
<tkinnen@sobhrach.com>
[RADIUS Test Engineer] - LUCENT Technologies RABU
"All of the opinions stated above are my own and not my
employer's,
unless they were given to me by my employer"
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive:
<URL:http://www.livingston.com/Tech/archive/>
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>