We have setup a T1 (channelized) on PM3...
We configured Line0 as given below,
---------------------- line0 - T1 Inband DS0 ---------------
Status: UP Framing: ESF Encoding: B8ZS PCM: u-law
Signaling: Trunk E&M wink start
Receive Level: +2dB to -7.5dB
Alarms Violations
----------------------------- -----------------------------
Blue 0 Bipolar 0
Yellow 0 CRC Errors 0
Receive Carrier Loss 0 Multiframe Sync 0
Loss of Sync 0
Is the above showned configuration is right or wrong ?
I have dialed using a phone to PM3, but iam unable to get the modem
tone...
It is just keeping silent...
Should i get the modem tone when i dialed to PM3 using a phone?...
TIA
With Warm Regards
Shibu R
_________________________________________________
Mailto : Shibu.Nair@med.ge.com
shibur@wipsys.soft.net
Tel : (414) 524 5261
Fax : (414) 896 2790
GE Medical Systems
Global Service Engineering
Pewaukee
Waukesha, WI 53072
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>