Whenever I start-up my PM25, the loading gets stuck at "Running ComOS..."
and never displays the login prompt. I have tried netbooting with the
generic PM25 image... same thing. Lucent tech support concluded that the
flash card is bad and would have to be replaced. This means, I might as
well throw away this unit. Before I do so, I thought I would consult this
list to see if anyone might have ideas on fixing the problem.
We are getting the following information from the console port (S0):
Livingston Enterprises, Inc. Boot Prom Rev J
Testing Low Memory....
Testing System Clock....
Testing System Memory.... 1024K
Checking Boot Rom....
Calibrating.... 33MHz
Starting FLASH Boot.....
Booting From Flash Type 28F010
Loading Image at 0fff0000
17076 flash copy complete
Verifying Load Module Checksum...
Starting Load Module ...
Loading kernel... 384944 bytes
Testing High Memory ... . 1024K
Found 25 ports....
ether0 active ... 64K burst-IO
hRunning ComOS...
TIA.
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>