Sorry to fill the list.
In <199904020554.PAA11266@thrasher.sub.net.au>, on 04/02/99 at 03:45 PM,
Mikel <mikel@sub.net.au> said:
>I have a PM3 connected to a E1 EuroISDN (Australian Telstra Onramp) line
>running 3.8.2
>show line0 gives me:
> line0 - E1 Primary Rate ISDN
> Status: UP F1 Framing: CRC4 Encoding: HDB3 PCM: a-law
> Violations:
> Bipolar 0
> CRC4 0
> E-Bit 107
> FAS Bit 0
>The E-Bit errors are not increasing though (I have logged a call with the
>Telco none the less).
>show s0 gives me:
> Status: NO-SERVICE
> Modem-Status: DCD- CTS+ TELCO+
>show m0 gives me:
> Card Type: LU1675 Chipset
> State: Ready
>Now, a search on the WWW pages tells me that DCD- CTS+ TELCO+ means the
>line and switch type is fine but the SPID is not set. However, I didn't
>know you have to set a SPID on EuroISDN lines and further down the page
>indeed it says that SPID's only need to be set for US isdn.
>Help?
>Regards,
>Mikel
Regards,
Mikel
-- ----------------------------------------------------------- Mikel Lindsaar | "The dream is the foundation, mikel@sub.net.au | of our society!" ----------------------------------------------------------- SubNet! http://www.sub.net.au/ ------------------------------------------------------------ To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message. Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>