I saw an answer. You may want to check you mail server.
> 1) I want to know whether PM3 "locations"(which are
> existing/created) are configured for analog call support or not ...?
> (set loc <location> analog on/off)
Yes, 'set loc <location> analog on'
> sh location command does not show the status of this
> analog option...
It should show it under options:
marion> show table loc
Location Destination Netmask Group Maxconn Type
------------ -------------------- --------------- ----- ------- ---------
marion> add loc test
Location test successfully added
marion> set loc test analog on
test analog dial changed from off to on
marion> show loc test
Location: test Type: Manual
Destination: 0.0.0.0 Netmask: 0.0.0.0
Protocol: PPP Options: Quiet, VJ-Comp, Analog
Group: 0 Max Ports: 0
Idle Timeout: 0 minutes High Mark: 0 bytes
Mtu: 1500 Async Map: 00000000
> 2) I heard only ComOs 3.8.2 and later will support for
> V.90 complaint calls... Is that true? (My PM3 version is 3.8)
ComOS 3.8 and above support incoming V.90 calls.
> 3) What is the alternate suggestion if i can not use AT
> commands on location table (scripts) on PM3 (PRI/Digital modem setup )
> (somebody specified on the mailing list)
What AT commands do you need to use? There should not be any needed for the
PM to dail correctly if the location options are set up correctly.
-- Thomas C Kinnen - <tkinnen@livingston.com> <tkinnen@sobhrach.com> [RADIUS Test Engineer] - LUCENT Technologies RABU "All of the opinions stated above are my own and not my employer's, unless they were given to me by my employer" - To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message. Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>