Re: copy location table?
Jon Lusky (lusky@edge.edge.net)
Wed, 20 Sep 1995 13:17:26 -0500 (CDT)
Dick St.Peters writes:
> Ok. I thought so. How do I transfer the configuration then?
>
> It sounds like we're back where this thread started. How can we
> transfer just the location table ... or the serial port configs, or
> the user table, or the filter table, or ... ?
>
> Just a way to dump the configuration in ascii, preferably as console
> commands, would do ... even just a way to post-process pmreadconf
> output ... but SOME way.
A console command that produced the equivalent of 'sho conf' on a Cisco
would be QUITE nice... just to be able to get the entire configuration
in one continuous scroll so I can capture it and then cut 'n paste it
back in when i have to reconfigure a portmaster from scratch. tftp
would be even better, but just an ascii dump of commands would be fine.
--
Jonathan R. Lusky | lusky@edge.net
http://www.hotrod.com |
------------------------|----------------
Edge Internet Services | (615) 726-8700