Re: My first time setting up Frame Relay, PM2ER30
Arnaud Girsch (girsch@marben.com)
Wed, 11 Dec 1996 14:35:58 -0800 (PST)
> I am successfully establishing a connection to the Frame switch at the
> Telco, and in debug mode, I can see the DLCI is set correctly, but I can't
> ping the other end of my PVC. That other end is having exactly the same
> problem, they can Establish, but can't ping my IP address. Both addresses
> are in the same subnet.
>
> My W1 config is shown below.
>
> If anyone could suggest what to try next, or even good general references,
> it would be much appreciated. If I've done something obviously stupid, let
> me know that as well.
Apparently, your Frame connection seems ok (as 'Established'). The problem
you have is at an IP level.
I think it could be interesting to see your routing table, associated to
these ports.
Arnaud.
--
Arnaud Girsch -+- agirsch@marben.com -+- Marben Products, Inc. - San Jose, CA