>I either need to increase the number of control sessions available, or
>make sure that there are not "ghost sessions" left after a control session
>has been disabled.
>Note: I only think there are two sessions open, the telnet, and then the
>pmwho fails.
>From 'Configuration Guide for PortMaster Products'
section 19-10 'Administrative Telnet Sessions'
Check for stale telnet sessions by typing show netcon....
Reset any connections that are stale by typing "reset n#" where # is the
handle from the first column of the show netcon output.
......
Admin telnets will show up as .23 on the netcon output.
Note: I use pmwho and pmcom as well and sometimes see this behavior when I
am absolutelty _positive_ that there is only 1 active and 0 stale sessions.