Re: K56Plus / x2 Modems

Marty Likier (marty@livingston.com)
Sun, 22 Dec 1996 07:45:26 -0800

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Jeff Halper: "Any command to modify a modem in the modem table"
Previous message: Marty Likier: "Re: Caller ID display on PM3"
Maybe in reply to: Ron Long: "K56Plus / x2 Modems"
Next in thread: Portmaster-Users Mailbox: "Re: K56Plus / x2 Modems"

At 09:37 AM 12/21/96 -0600, Ron Long wrote:
>Will this technology work with the PM2 product line? That is assuming you
>have a rack of modems with a T1 interface (PRI not available here) I have
>gotten confused after reading white paper after black paper, after blue
>paper. I understand that to work, the ISP must have a digital connection
>to the CO (T1 / PRI) but what happens when the signal comes out of the
>modem into a 232 cable and into the PM2? Does this nullify the digital
>connection?

This would work fine. The signal only has to remain digital on the telco
side. The rs-232 backend is no problem.

--
 Marty Likier
 Product Marketing Mgr.
 marty@livingston.com

Next message: Jeff Halper: "Any command to modify a modem in the modem table"
Previous message: Marty Likier: "Re: Caller ID display on PM3"
Maybe in reply to: Ron Long: "K56Plus / x2 Modems"
Next in thread: Portmaster-Users Mailbox: "Re: K56Plus / x2 Modems"