> addresses are part of an OSPF area but the PM3
> to which the cisco connects only advertises a
> /32 of "the dest ip address" over OSPF A show sx
> of the connected port also shows a /32 subnet?
> I have configured a /29 subnet when I setup the
> user so why isn't this subnet used between the
> PM3 and the cisco?
Has a 'set user-netmask on' been issued on the PM?
> The first problem we had is that the connection only
> works in numbered setup. (which means I had to add the
> user to the local PM3 user table and not into radius as
> radius doesn't support the local-ip-address setting)
> Anyone knowing a better solution here?
Have you done a set reported on the PM?
-- Thomas C Kinnen - <tkinnen@livingston.com> <tkinnen@sobhrach.com> [RADIUS Test Engineer] - LUCENT Technologies RABU "All of the opinions stated above are my own and not my employer's, unless they were given to me by my employer" - To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message. Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>